This puts ALL of them under automatic control of their speeds, guided by the temperature sensor built into the CPU chip. For the RAD FAN MOTORS the system provides a Splitter to allow you to connect all three of them to the CPU_FAN header. Plug the Pump motor into the AIO_PUMP header and re-enable the failure detection.Ģ.
IF your mobo does NOT have that header, the alternative connection possible with a cable supplied allows you to power the pump motor directly from the PSU via a SATA power connector, BUT that eliminates the ability to monitor it for failure. IF it gets no pump speed signal at that header it will warn you of that failure, and that is what you saw and defeated. This does two things - provides a constant +12 VDC power supply to keep the pump at full speed always, and monitors that pump speed signal for FAILURE.
The cable from the PUMP MOTOR ideally should go to the mobo AIO_PUMP header which you have - see your mobo manual, p. What the instructions provided tell you is this.ġ. We're talking here about power and speed control for the PUMP rad the rad fan MOTORS only - not about the lights.
0 kommentar(er)
